Wondering if something like this would work for fuse/Iec/switch. Don't have white wire on hand. The Grey is connected (temporarily) to xpwr white ground. Black is 125v.
Here the enclosure as of 10 minutes ago.
An externally hosted image should be here but it was not working when we last tested it.
Here the enclosure as of 10 minutes ago.
An externally hosted image should be here but it was not working when we last tested it.
Last edited:
Pulled out some of the wood stash thinking the 3rd attempt at a base could be successful. How long should I run this with meters attached?
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
a while back C1 puked it guts out because I had the polarity wrong. Rat Shack didn't have a replacement so I just reused the original 15000uf 10v electrolytic minus half it's fluid. The new part arrived along with a few different C4's. My him is almost non existent. I need to stick my ear within a few inches to hear tweet hum/hiss. Outstanding with these very sensitive Cornwalls.
Upgrade iron suggestions please.
Upgrade iron suggestions please.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- More Vendors...
- Tubelab
- TSE & 45's