• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Potential MPC74 Fukushima resistors GB for EUVL's FX5

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
A

AndrewT

R.I.P.
Joined 2004
string your 0r47 resistors in series.
Pass ~200mAdc through the string.

Each resistor will show ~94mVdc on a 199.9mVdc DMM and dissipate ~20mW and thus stay very close to Ta.

You can pick out which resistors have the closest Vdrop.
If you have a couple, or more, of 1r0 1% resistors you can also mark on the 1% accuracy resistance on the 5% or 10% resistors.

If you have some close matches then push the current to 400mAdc and use the full resolution of your 2000count DMM.
 
Last edited:
H

heinz1

Member
Joined 2008
Did you move recently?

This question came into my mind when I looked again at my spreadsheet containing the addresses I have collected approximately ten months ago.

As we are now hopefully approaching shipment, please ensure that the address we have is still correct and notify me or your local distributor of any possible changes.

TIA!
 
Horio

Horio

Member
Joined 2010
Heinz1, I think that is very wise for us to confirm everyone's address prior to shipment from the distributors. I am planning to contact all of the North American participants, and ask for their mailing address prior to shipment. Just to be safe I'd suggest that you and John do the same for the participants in your region.

Thanks,
Greg
 
Horio

Horio

Member
Joined 2010
Quick update:

All of the Fuku resistors have been matched and grouped into sets of (8). I have packaged up the Fuku resistors along with the PRP/Mosfet/Keratherm parts for those who participated in that group buy as well.

I plan to ship the parts to the regional distributors tomorrow. For the North American participants, I will begin mailing out your parts this week.

Thanks again for everyone's patience.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom