hypex ncore

[Zoran]

Thanks again
.
R141=Rg=1.2k
Rf=2.2k
for the NC-400 model
that is what I found in one of the Brunos post
Yes There is no need to change the Rf i was just curious
Thanks
now it is clear
I just need +3db additional gain...

[Julf]

Originally Posted by Zoran

I just need +3db additional gain...

Just be aware that increasing gain lowers the feedback. While Bruno has commented that increasing feedback is OK, I think you might be in somewhat uncharted waters if you actually lower the feedback from the nominal.

Very interested in hearing your experiences if you try it.

[Zoran]

According to the present datas should be something like this
(for the 680 ohm Rg, +4db input stage gain)

[yetis]

Hi,

Quick question. Can someone point me toward the connector for J1 on the SMPS? I have looked for item # JST-B7B-EHA on Digikey, with no luck. This looks like it, but not the correct item #. I seem to have thrown out the ones that came with my units and need them now.

Thank you

[jlaakso]

Ask Hypex?

[ua100k]

Originally Posted by yetis

Hi,

Quick question. Can someone point me toward the connector for J1 on the SMPS? I have looked for item # JST-B7B-EHA on Digikey, with no luck. This looks like it, but not the correct item #. I seem to have thrown out the ones that came with my units and need them now.

Thank you

Digi-Key Part Number
455-1005-ND - Housing.
455-1042-1-ND Crimp

[pos]

While we are at it, would someone know the exact reference of the female crimp terminal to use with the microfit molex connector 43025-1200 ?
I think it is the 43030, but several version exists:
View List

What is the AWG of the wire?

I would like to fit 2 (or myabe even 3) wires per connector, so if the original AWG is 24, 2 of them should fit no problem in the 20-24 AWG model...

Also, do you know if special tools are required to assembled those crimps, or will a simple crimp tool be sufficient?

[Rajapruk]

My 3 monoblocks with bridged nc400 and SMPS1200A400, built by my friend Georg.

We have compared them against the standard nc400+SMPS600 in a dual-mono config today. The bridged ones sounds much more "alive", and they are not even broken in. The standard ones sounds flatter. Less dynamics.

The monoblocks has version 4 of nc400. The dual-mono has version 3. What was the changes made in version 4?

[Julf]

Originally Posted by Rajapruk

We have compared them against the standard nc400+SMPS600 in a dual-mono config today. The bridged ones sounds much more "alive", and they are not even broken in. The standard ones sounds flatter. Less dynamics.

Did you do the comparison as a double-blind ABX, or as a sighted subjective evaluation?

[ds23man]

Originally Posted by Rajapruk

My 3 monoblocks with bridged nc400 and SMPS1200A400, built by my friend Georg.

We have compared them against the standard nc400+SMPS600 in a dual-mono config today. The bridged ones sounds much more "alive", and they are not even broken in. The standard ones sounds flatter. Less dynamics.

The monoblocks has version 4 of nc400. The dual-mono has version 3. What was the changes made in version 4?

I am missing the cap across the output terminals!