Please find attached PCB layout for IGC, suitable for multichannel GC poweramps. My friend Max made them, and they are cute
The pcb layout was designed for using ERO MKP 1841 filmcaps
http://www.vishay.com/docs/26019/mkp1841.pdf
and Caddock MP915 0,22 R at output.
1000uf's are Elna snap-in types, a bit larger than for example Panasonic FA or FC's, but those will fit also.
Both of these two circuit variations can be used:
http://ampchipdiy.com/invertedLM3875_r2_1.gif
http://home.comcast.net/~greggbaker/invertedLM3875.gif
Suitable pwr-bridge circuit/pcb could be this one:
http://www.diyaudio.com/forums/showthread.php?postid=269537#post269537
PCB was designed so that the unused pins of LM3875T should be cut of.
/Jan
The pcb layout was designed for using ERO MKP 1841 filmcaps
http://www.vishay.com/docs/26019/mkp1841.pdf
and Caddock MP915 0,22 R at output.
1000uf's are Elna snap-in types, a bit larger than for example Panasonic FA or FC's, but those will fit also.
Both of these two circuit variations can be used:
http://ampchipdiy.com/invertedLM3875_r2_1.gif
http://home.comcast.net/~greggbaker/invertedLM3875.gif
Suitable pwr-bridge circuit/pcb could be this one:
http://www.diyaudio.com/forums/showthread.php?postid=269537#post269537
PCB was designed so that the unused pins of LM3875T should be cut of.
/Jan
Attachments
Attachments
palesha said:We were very much impressed with the picture of bridge pcb posted on 11-23-2003. i will like to know which software u used to draw the same. Waiting for ur reply
Mahendra Palesha
My friend who did the pcb layout used Circad.
An evaluation copy can be dowloaded at http://www.holophase.com/
/Jan
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Chip Amps
- PCB for Inverted Gainclone