BRX2416.1D Goes into protection
I am having a issue with a BRX2416.1D hifonics that goes into protection after a few seconds of powering up. I have attached two images of the power supply driver card and the output driver card both with arrows which are connected together when traced.
If I place the tester lead to ground and place the positive lead on any of these points the amplifier will power up and is OK. when I remove the lead from the point the amplifier goes back to protection.
Is anyone familiar with this issue can assist.?
I am having a issue with a BRX2416.1D hifonics that goes into protection after a few seconds of powering up. I have attached two images of the power supply driver card and the output driver card both with arrows which are connected together when traced.
If I place the tester lead to ground and place the positive lead on any of these points the amplifier will power up and is OK. when I remove the lead from the point the amplifier goes back to protection.
Is anyone familiar with this issue can assist.?
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Hifonics brx2416.1d