Cap tolerances can be anywhere from 0.3% to 50%
but plastic are usually 5% or 10%.
If 6u7F is specified, then select very low measured 6u8F or assemble a group to give 6u7F
But buying two 10% 6u8F could give you a 6u58F and a 7u21F
How do you get both channels close to 6.7?
but plastic are usually 5% or 10%.
If 6u7F is specified, then select very low measured 6u8F or assemble a group to give 6u7F
But buying two 10% 6u8F could give you a 6u58F and a 7u21F
How do you get both channels close to 6.7?
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.