I am rebuilding a pair of MK3 dynaco monoblocks. I need binding posts. I have been going around and around on what to use.
I will be using banana plugs. I just need a good clean solid reliable connection. I don't want to have to take the amps back apart to replace connectors with bad plating or whatever.
Whats the best bang for the buck? I can't afford WBT.
Ideally I could get 6 so I could have posts for common, 4 and 8 ohm taps on the back.
Thanks everyone - Evan
I will be using banana plugs. I just need a good clean solid reliable connection. I don't want to have to take the amps back apart to replace connectors with bad plating or whatever.
Whats the best bang for the buck? I can't afford WBT.
Ideally I could get 6 so I could have posts for common, 4 and 8 ohm taps on the back.
Thanks everyone - Evan
Parts Express offers some of their own brand (Dayton) that are good quality at a lower price.
http://www.partsexpress.com/webpage.cfm?&Webpage_ID=3&CAT_ID=39&ObjectGroup_ID=107&SO=2
http://www.partsexpress.com/webpage.cfm?&Webpage_ID=3&CAT_ID=39&ObjectGroup_ID=107&SO=2
Banned
Joined 2002
I bought a few set's of these.
Gold Plated 5 way Binding Posts Red & Black $4.59/Pair 10 pair $42.50
http://www.apexjr.com/new.htm
Very good quality, and nice looking.
Jase
Gold Plated 5 way Binding Posts Red & Black $4.59/Pair 10 pair $42.50
http://www.apexjr.com/new.htm
Very good quality, and nice looking.
Jase
Banned
Joined 2002
240z4u said:I was considering both the apexjr units AND the parts express ones.
Glad you guys have actually seen them up close and personal. I was worried the build quality wouldnt be so great.
The audionotes look promising too though.
Thanks folks, keep the info coming!!!
Evan
Do you want a better picture ?
Banned
Joined 2002
I've also got these on my other speakers, they are ok too!
http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=091-622
Jase
http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=091-622
Jase
jleaman said:I've also got these on my other speakers, they are ok too!
http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=091-622
Jase
But then you have to buy the binding plate too don't you? There isn't any way to cut a notch into MDF for the " keyed 11.5mm hole" ??
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Design & Build
- Parts
- What do you guys reccomend for binding posts?