For Sale VPI HW-19

[cygnus x1]

VPI HW-19 clone. New Oak Base w/ cork and Sorbathane pucks, New 3/8"Acrylic- 3/8"MDF constrained layer plinth, New Hurst motor that was sent to VPI to add Brass step bushing (less then 10 hrs use..still needs breaking in) for noise reduction. New VPI Pulley. DIY 10" tonearm (made from Technics arm) with Purpleheart wood headshell, arm tube damped with fiberglass/silicone. Lead damped counterweight. New tone arm wire.

Will consider parting out to save shipping weight.

Platter-Bearnig $175
Motor $250
Pulley $75
Plinth $75 (Acrylic only $50)
Arm $75
Base $100

PayPal and buyer pays

 

[cygnus x1]

DIY Special. Platter w/ bearing, motor and pulley, belt $400. If you buy that, I'll sell you the arm for $50.

 

[cygnus x1]

Now with internal SAMA. Sold as complete table only ($500).

 

[scotteboy]

Now with internal SAMA. Sold as complete table only ($500).

Sold ?

 

[cygnus x1]

Nope, just saying the setup includes the SAMA.

 

[Philco2020]

I'm jumping back into vinyl after a long (very long actually) hiatus and would like to have a decent cartridge already mounted.....until I get my sea legs back and start running down that rabbit hole.
Any chance of that?

 

[cygnus x1]

I could work something out. PM me.

 

[cygnus x1]

Last call before eBay.

 

[astrojet]

pm forthcoming.

 

[cygnus x1]

DIY Kit as above $350.00 Going...going...

 

[cygnus x1]

Still have.

 

[audiowize]

Where are you located?

 

[scotteboy]

Hi , I am in Huntsville ,AL and noticed I never replied, probably because I bought a hw-19 for a steal. I have a friend that would like to build a turntable and I liked your design. Wondering if you had any plans or items for sale or knew of any . I have a platter, bearing, cover and armboard for a hw-19.

 

[cygnus x1]

Send me a PM.

 

[scotteboy]

Thank you for your response, it won’t let me pm you , says I m still under moderation. I am mostly on audiokarma but read content here from time to time.