I need to get a couple of DMMs calibrated and I would love to hear suggestions or recommendations from the experts here on who could provide this service in the UK. The DMMs are HP34401a and Fluke 8842a.
As a home engineer (hobbyist!) I'm looking for an affordable solution.
Many thanks!
terry
As a home engineer (hobbyist!) I'm looking for an affordable solution.
Many thanks!
terry
I need to get a couple of DMMs calibrated and I would love to hear suggestions or recommendations from the experts here on who could provide this service in the UK. The DMMs are HP34401a and Fluke 8842a.
As a home engineer (hobbyist!) I'm looking for an affordable solution.
Many thanks!
terry
I wonder is there differences in measurements between the two that give you pause?
"Calibration service" never involves cracking open the instruments case. It assures traceability to some official standard, usually required for contractual requirements. E.g. They'll give you a piece of paper and bless your gear. IMO These days service and repair rarely goes into the level of factory re-alignment.
There are a number of companies in the UK that offer a calibration service. Unless your DMMs are worth a lot, say over £50 each, I would look to replace them.
These guys seem to know what they are doing;
These guys seem to know what they are doing;
- Testermans
11 Crab Marsh
Wisbech
Cambridgeshire
PE13 3JG
United Kingdom
VAT: GB 855 0120 55 - 01945 738112
- sales@testermans.co.uk
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.