Manoj, Please do not post password protected materials to the forum - anything posted here must be available to all members without exception. Attachments here are not available to non members.
In the future please ask people to PM you for files you are unwilling to share at large.
Let's get back on topic, people please do not post requests for passwords here, PM Manoj directly.
Thread cleaned up (posts deleted)
In the future please ask people to PM you for files you are unwilling to share at large.
Let's get back on topic, people please do not post requests for passwords here, PM Manoj directly.
Thread cleaned up (posts deleted)
UCD Protection against short circuit at output speaker. - YouTube
SHORT CIRCUIT PROTECTION by norazmi
SHORT CIRCUIT PROTECTION by norazmi
??????????? power amp class d ??????? IR-6000d ?????? load 2 ???
Hi Sameerxi
greetings same heat sink fitting for amp
warm regards
andrew
Hi Sameerxi
greetings same heat sink fitting for amp
warm regards
andrew
Yes, i mean on schematic, I really like to see it... Did you use ompoarator LM311, do you resolove noise problem?
Hi Dzony988,
yes I'm using LM311 and its a carrier based class d amp not UCD(self osc).fsw=250KHz or you can change fsw and no noise issues. if you want it PM me
Regards
MANOJ
Hi red_zone003,Anybody tested this circuit? I have all the parts and i need your advices. I want to use irfb4227, with +/-100v or 90v. This circuit will be able to provide 1000w in 8ohm? Thanks
That will not work. IR2110 high and low input change it will not switch. so don't go
Regards
MANOJ
- Home
- Amplifiers
- Class D
- UCD 25 watts to 1200 watts using 2 mosfets