so i built troels' W18 crossover version 2 as shown here,
but built a TQWT for the 18W/8434G00 using the calculator here
HiFi Loudspeaker Design
do i have to mod the initial trap value for 18w? if so how?
thanks
but built a TQWT for the 18W/8434G00 using the calculator here
HiFi Loudspeaker Design
do i have to mod the initial trap value for 18w? if so how?
thanks
Why the first ? The first is the lowpass ( the L ) plus some EQ ( the RC parallel to the L ) for the high frequencies.
The second is the impedance flattening network ( RC ) and the third is a RLC network centered on some peak in frequency response; probably, this is where you should point, as a different load might change cone behaviour .
The second is the impedance flattening network ( RC ) and the third is a RLC network centered on some peak in frequency response; probably, this is where you should point, as a different load might change cone behaviour .
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.