I don't know what the 1010F is, are you sure that that's the right part number?
The IRF1010EZ is a good PS FET and could have been original but they typically use a Fairchild FET like an FQP65N06.
The IRF1010 is typically a low voltage FET. It could not have been an output unless the rail voltage is well under 60v.
Someone else may have a more definitive answer.
To upload photos click the following:
Go Advanced
Manage Attachments
Browse
Upload
Repeat as necessary
Preview post to see how the post will look.
Click Submit Reply to send it to the forum.
The IRF1010EZ is a good PS FET and could have been original but they typically use a Fairchild FET like an FQP65N06.
The IRF1010 is typically a low voltage FET. It could not have been an output unless the rail voltage is well under 60v.
Someone else may have a more definitive answer.
To upload photos click the following:
Go Advanced
Manage Attachments
Browse
Upload
Repeat as necessary
Preview post to see how the post will look.
Click Submit Reply to send it to the forum.
The IRF3710 were commonly used but the new IRF3710 won't generally work. The IRF3710Z must be used. I don't know how much you know about this type of amp but the HIP4080 virtually always fails when the outputs fail.
Search the car audio forum for >> HIP4080 << and you'll see a lot of the problems and test procedures for this type of amp.
Search the car audio forum for >> HIP4080 << and you'll see a lot of the problems and test procedures for this type of amp.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.