In my cheapo-vintage-Toshiba-integrated-amplifier, I decided to bypass the tone control board. I removed the ground wire and connected Lin with Lout and Rin with Rout together.
Since I've done this, the gain turned lower than before : I have to put volume pot on 2 instead of ½. Also, now, the gain and tone greatly depends of the source. The tuner sounds crappy with tons of bass, and the CD player is clear, loud and practically bass free.
Does someone knows how can this happen? Impedance?
Since I've done this, the gain turned lower than before : I have to put volume pot on 2 instead of ½. Also, now, the gain and tone greatly depends of the source. The tuner sounds crappy with tons of bass, and the CD player is clear, loud and practically bass free.
Does someone knows how can this happen? Impedance?
Hi DragonMaster,
Is it possible that your tone control circuit is in the feedback loop of the amplifer stage?. To test, put a 22K resistor between the in and out. If the tone controls were in the feedback network the gain will go up. Install an equivalent resistance to the impedance of the tone control circuit. Trial and error with on channel will get you there.
-Chris
Is it possible that your tone control circuit is in the feedback loop of the amplifer stage?. To test, put a 22K resistor between the in and out. If the tone controls were in the feedback network the gain will go up. Install an equivalent resistance to the impedance of the tone control circuit. Trial and error with on channel will get you there.
-Chris
It's really easy to compare even without trying one channel at the time. The step between 1/2 and 2 on this amplifier is enormous.
You can make the difference between normal and really loud easily without doing it 1 chan @ the time.
I've got PAs, so 2 is way too much, even with a 40w/chan amp.
You can make the difference between normal and really loud easily without doing it 1 chan @ the time.
I've got PAs, so 2 is way too much, even with a 40w/chan amp.
Tomorrow I'll have the amp under hand and I'll be near the local shop, so I can get some resistors.
Putting resistors will be helpful to make the volume more stable, but I'll be stuck with pot tracking problems. Between 0 and 1, the tracking is really unstable, there are bumps in the volume that are different between both channels. The problem is that it's not really easy to find 4-pin/channel pots.
Also, when the tone board was connected, the balance was working worse than now(It still is) : It was not working until -8/+8. The only effect it had was that it would trigger the channels on and off.
Putting resistors will be helpful to make the volume more stable, but I'll be stuck with pot tracking problems. Between 0 and 1, the tracking is really unstable, there are bumps in the volume that are different between both channels. The problem is that it's not really easy to find 4-pin/channel pots.
Also, when the tone board was connected, the balance was working worse than now(It still is) : It was not working until -8/+8. The only effect it had was that it would trigger the channels on and off.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Solid State
- Tone ctrl bypass reduces volume?