alazira,
thanks for your recipe in post number 433.
I was asking for this in a post earlier. Tried it with a 5.45V and works great.
Will fit nicely side-to side for builds with 2 pos regs.
kind regards.
thanks for your recipe in post number 433.
I was asked by PM about the neg to pos conversion so rather than separate replies I'll share here:
I was asking for this in a post earlier. Tried it with a 5.45V and works great.
Will fit nicely side-to side for builds with 2 pos regs.
kind regards.
Attachments
For a phono MC pre-pre the C101-201-301 position wich value will be better 220uF or 1000uf like for digital clocks?
bump
alazira,
thanks for your recipe in post number 433.
I was asking for this in a post earlier. Tried it with a 5.45V and works great.
Will fit nicely side-to side for builds with 2 pos regs.
kind regards.
Hi necplusultra,
I'm glad it worked for you. I see you are using an electrolytic for C203. Is R207 a jumper?
Just received the BiB boards from teabag. Looking to power an old Quad FM4 tuner which requires 12V at 30mA (according to repair manual).
Any guidance would be appreciated. Also anything wrong with Mundorf AG 4700uF, 63V (I have been using the latter and decided I prefered a Panasonic FC but does anyone else have an opinion?).
Chris
Any guidance would be appreciated. Also anything wrong with Mundorf AG 4700uF, 63V (I have been using the latter and decided I prefered a Panasonic FC but does anyone else have an opinion?).
Chris
Also anything wrong with Mundorf AG 4700uF, 63V (I have been using the latter and decided I prefered a Panasonic FC but does anyone else have an opinion?).
Chris
I should have said I was using the cap on another power supply project.
- Home
- Amplifiers
- Power Supplies
- SSLV1.1 builds & fairy tales