Please could someone assist me in fooling/ bypassing the lamp ballast on my sanyo plc-xu74 projector.
the ballast is a euc 200d v11.
I have tried the jumping of the wires going into the motherboard (red and white) and i have no luck.
I want to run my projector on HID lamp and ballast separately powered from the projector.
any advise will be greatly appreciated.
the ballast is a euc 200d v11.
I have tried the jumping of the wires going into the motherboard (red and white) and i have no luck.
I want to run my projector on HID lamp and ballast separately powered from the projector.
any advise will be greatly appreciated.
Attachments
I heave Sanyo plc xu70 and same board and same problem
This is service manuals.
https://www.file-upload.com/r7xfxhfz8clg
This is service manuals.
https://www.file-upload.com/r7xfxhfz8clg
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.