hello !
i'm looking to build an aleph 3
i will use kk-PCB
wich inductors must be used
this are correct or not ? :
http://www.tdk.co.jp/tefe02/e93_tf.pdf
i built a dual mono ,i must use 2 inductors ?
because this inductors have 4 leads how can connect them ?
i'm looking to build an aleph 3
i will use kk-PCB
wich inductors must be used
this are correct or not ? :
http://www.tdk.co.jp/tefe02/e93_tf.pdf
i built a dual mono ,i must use 2 inductors ?
because this inductors have 4 leads how can connect them ?
there isn't 2.2mh at MCM
can i use this :
http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=266-375
or this :
http://www.riviera-acoustics.com/catalog/product_info.php?cPath=46_24_70_73&products_id=338
these are air core inductor too !
can i use this :
http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=266-375
or this :
http://www.riviera-acoustics.com/catalog/product_info.php?cPath=46_24_70_73&products_id=338
these are air core inductor too !
i think i have my answer
for choke's I urge you to look at what intertechnik have to offer, you'r looking for air-core coils. I use a CRC filter, because power resistors are cheaper
If you can't find the right inductors
Maybe just copy the power supply shown in the F1 Service Manual
on the First Watt web page.
I bet that would work quite well![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Maybe just copy the power supply shown in the F1 Service Manual
on the First Watt web page.
I bet that would work quite well
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- questions about aleph 3