This amp is the same design that many amp manufactors use..
This is the board where the Audio driverboard sits in front of a fan..
Amp powers up idels perfectly all rail and regualted voltages are correct..
Amp has very very low output u have to put your ear to the test spaeker in order to hear it..
Any ideas what might cause this??
This is the board where the Audio driverboard sits in front of a fan..
Amp powers up idels perfectly all rail and regualted voltages are correct..
Amp has very very low output u have to put your ear to the test spaeker in order to hear it..
Any ideas what might cause this??
Ok fixed that now i have another issue..
A screwdrive rolled across my bench and hit 1 of the outputs when that amp was powerd up..
had a big spark but it didnt blow the output ..
I removed the output and powerd the amp up again now it stuck in protection mode..
If i remove all the low side outputs amp will power up and idle fine..
I tryed to put 1 brand new output on the low side but as soon as i do the amp protects..
Would the driverboard be the most likely cause of this??
A screwdrive rolled across my bench and hit 1 of the outputs when that amp was powerd up..
had a big spark but it didnt blow the output ..
I removed the output and powerd the amp up again now it stuck in protection mode..
If i remove all the low side outputs amp will power up and idle fine..
I tryed to put 1 brand new output on the low side but as soon as i do the amp protects..
Would the driverboard be the most likely cause of this??
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Power Acoustic OV1-5500D