pass labas x2-1
these are the components that
these are the components that
An externally hosted image should be here but it was not working when we last tested it.
have welded the Q5 in the bottom of the X2Original
Hola Miguel,
Just leave it like ZM said they look original to me.
The only thing I would have done differently is put a (isolating) sleeve over the leads of the components but nevertheless it'll still work if you don't touch them.
I urge you to test the whole amp by using the schematic you send me and if everything is OK than you need to go deeper in to troubleshooting cause by replacing the (damaged) parts alone and not getting the amp to sound good you will be needing a helping hand from a friend who can fix it for you.
Again, it's not difficult to do this and with proper explanation you'll be able to fix it.
Now a question in Spain for you: Tienes el ruido o soplo en anbos vocinas o solamente en uno de los dos?
Do you hear the noise in both speakers or just one?
Gracias, Thanks,
Audiofanatic
Hola Miguel,
Just leave it like ZM said they look original to me.
The only thing I would have done differently is put a (isolating) sleeve over the leads of the components but nevertheless it'll still work if you don't touch them.
I urge you to test the whole amp by using the schematic you send me and if everything is OK than you need to go deeper in to troubleshooting cause by replacing the (damaged) parts alone and not getting the amp to sound good you will be needing a helping hand from a friend who can fix it for you.
Again, it's not difficult to do this and with proper explanation you'll be able to fix it.
Now a question in Spain for you: Tienes el ruido o soplo en anbos vocinas o solamente en uno de los dos?
Do you hear the noise in both speakers or just one?
Gracias, Thanks,
Audiofanatic
anyone know of few Kohm potentiometer is Pass Labs X2-1
and if you can put something better as a DACT.
and if you can put something better as a DACT.
An externally hosted image should be here but it was not working when we last tested it.
anyone know of few Kohm potentiometer is Pass Labs X2-1
and if you can put something better as a DACT.
An externally hosted image should be here but it was not working when we last tested it.
This pot have the same quality as DACT, don't touch it.
the elna are superb quality, especially for the money and if you contact them directly you can customise the stops and switching behaviour. if you want to bling it up, find the positions you use most often and replace the smd resistor with ASMP texas components naked Zfoil SMD resistor. its better than DACT imo but similar to some DACT models, maybe even manufactured for DACT
because there may be blowing or background noise in the preamp at low volume?
Since I can only change the IRF610 which incidentally are heated much 3.3K resistors, out of print for any use which has, I could help and not to do because the voltages are OK.
Greetings to all.
Since I can only change the IRF610 which incidentally are heated much 3.3K resistors, out of print for any use which has, I could help and not to do because the voltages are OK.
Greetings to all.
this is third thread you're opening for same preamp with same problems .
conclusion - either we aren't capable to help you because of language barrier , or you aren't good enough in electronic to repair it even with our help ;
take that jewel to someone who knows what to do
conclusion - either we aren't capable to help you because of language barrier , or you aren't good enough in electronic to repair it even with our help ;
take that jewel to someone who knows what to do
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- pass labs x2-1