Hi !
I can't tell you it's bad
All who have listened quoted it very good
Power is indicated on the schemo, some 8W before clipping.
There was a thread about here:
http://www.diyaudio.com/forums/showthread.php?s=&threadid=53969&highlight=
Yves.
I can't tell you it's bad
All who have listened quoted it very good
Power is indicated on the schemo, some 8W before clipping.
There was a thread about here:
http://www.diyaudio.com/forums/showthread.php?s=&threadid=53969&highlight=
Yves.
Not properly. ECL86 works at lower voltage and has higher resistance. The driver triode compared to 12ax7 has reduced Ra at the same voltage, the output pentode is closer to EL86 than El84.
Despite these inaccurate comparison, the schematic from Yves is different to all published on the net and is simple, clever and cheap (less tube, simplified wiring..).
Yves have You also the winding and constructional data of the transformers? If You'll provide a transformer kit for this project, I book one!
Despite these inaccurate comparison, the schematic from Yves is different to all published on the net and is simple, clever and cheap (less tube, simplified wiring..).
Yves have You also the winding and constructional data of the transformers? If You'll provide a transformer kit for this project, I book one!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.