Yes.It measures 5V at output tube socket. I set this up for 300B so I assume this is what I want.
They should be similar (around -80v for mine). Measure from output tube socket where it says "1" in both channels.Output grid voltage at R14 and R25 when set to most negative voltage are -89 and -295V respectively. Is this right? Why the difference?
I will check tube socket 1 tomorrow after work. I guess the abnormal voltage has its effect. right channel/speaker is not playing.
B+ is 372V at grid bias of 63mA on Right and 67mA in left. Rectifier is the brightest with bright orange, output tubes barely glow but when seen from top there is glow. No smell of burning plastic either. Don't know why there is o output from right. Any suggestions, I will look into it tomorrow.
By the way, one speaker is way way way loud for a 15X26 foot room. By mistake I omitted volume pot, that thing goes in first. Connected a Denon DVD player with no volume control. Big mistake.
B+ is 372V at grid bias of 63mA on Right and 67mA in left. Rectifier is the brightest with bright orange, output tubes barely glow but when seen from top there is glow. No smell of burning plastic either. Don't know why there is o output from right. Any suggestions, I will look into it tomorrow.
By the way, one speaker is way way way loud for a 15X26 foot room. By mistake I omitted volume pot, that thing goes in first. Connected a Denon DVD player with no volume control. Big mistake.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- More Vendors...
- Tubelab
- Output filament suppy