Pass Labs PCB and recommended electronic parts.
DH Labs and Cardas wires
Cardas RCA and binding post
Cardas euthetic solder
Still missing: front blue led, front on/off switch and logo. I am planning to make a front plate like the X series soon.
See my web site for other pictures...
DH Labs and Cardas wires
Cardas RCA and binding post
Cardas euthetic solder
Still missing: front blue led, front on/off switch and logo. I am planning to make a front plate like the X series soon.
See my web site for other pictures...
Attachments
Thank you very much!
The amplifier is 12'' x 9'' x 20'' and there is one transistor per heatsink section. The biggest Zen V4?
The bias is set for 4 ohms and the amplifier is running quite hot but we can touch it for a few seconds
The sound is very impressive, a lot of details. I am rediscovering many CD I don't regret to put so much money and hours in it.
As for the blue led, I have a few ideas that nobody did until now...
I am now ready for the preamp...according to the other people, I guess I will build the BZLS and use it non-balanced.
The amplifier is 12'' x 9'' x 20'' and there is one transistor per heatsink section. The biggest Zen V4?
The bias is set for 4 ohms and the amplifier is running quite hot but we can touch it for a few seconds
The sound is very impressive, a lot of details. I am rediscovering many CD I don't regret to put so much money and hours in it.
As for the blue led, I have a few ideas that nobody did until now...
I am now ready for the preamp...according to the other people, I guess I will build the BZLS and use it non-balanced.
François,
Good work, pretty impressive.
Best regards.
PS: I am preparing a CCS-X-BOSOZ, I already have built a prototype
with 2 channels, (1 with a NPN CCS and the other with a IRF610 CCS)
it's working fine. Nelson said that CCS's were best for inputs or outputs unbalanced.
I would like to listen to your amp, is it possible ?
Alain.
Good work, pretty impressive.
Best regards.
PS: I am preparing a CCS-X-BOSOZ, I already have built a prototype
with 2 channels, (1 with a NPN CCS and the other with a IRF610 CCS)
it's working fine. Nelson said that CCS's were best for inputs or outputs unbalanced.
I would like to listen to your amp, is it possible ?
Alain.
Beautifully made Francois! But hold it... my Zv4 has 15"x26"x8" (WDH) chassis dimensions...it's not yet singing though.
http://www.diyaudio.com/forums/showthread.php?s=&threadid=26221&pagenumber=1
http://www.diyaudio.com/forums/showthread.php?s=&threadid=26221&pagenumber=1
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- New Zen V4 released