Hi:
I am not exactly sure if this is the correct place to put this but I am sure if not someone will help me find the correct place.
I am building a speaker enclosure for a guitar. I want to make it vented and all the programs I have found to help design do not well explain the port vent.
How do I determine how big (diameter) the port should be so I can figure how long it should be?
Secondly I need to find a manufacturer in the US (better in NJ) that makes pcbs (populated) for some amps I am working on. Is the vendor section a good place to ask for this or is there a better way to find these people?
Thanks
I am not exactly sure if this is the correct place to put this but I am sure if not someone will help me find the correct place.
I am building a speaker enclosure for a guitar. I want to make it vented and all the programs I have found to help design do not well explain the port vent.
How do I determine how big (diameter) the port should be so I can figure how long it should be?
Secondly I need to find a manufacturer in the US (better in NJ) that makes pcbs (populated) for some amps I am working on. Is the vendor section a good place to ask for this or is there a better way to find these people?
Thanks
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.