Been asked to put together a higher VA PSU for a MF XLP series unit. I know it needs 2 x 12 VAC to a 4 pin din plug, I would like to build as far as I can before getting the sample to measure.
My X-PSU uses a three pin DIN plug. The DIN is used for the transformer taps only. The two outer pins are for the secondaries,
the middle pin for the common tap of the secondaries. Hope this helps.
Could have sworn it was four pin but hey, it was a while ago. Will check it, if 3 pin I am sure it helps. You mean middle pin is centre tap and outer pins ~ Voltage I think.