Hello,
I want to buld a gainclone with the LM3876, with the same outline as the LM3875, is that possible?
I know that the lm3876 pin 7 goes to gnd, and pin 8 is for mute.
I don't want to connect these two pins in the. and make it exact like the lm3875 non-inverted version.
Thanks,
Bobossa
I want to buld a gainclone with the LM3876, with the same outline as the LM3875, is that possible?
I know that the lm3876 pin 7 goes to gnd, and pin 8 is for mute.
I don't want to connect these two pins in the. and make it exact like the lm3875 non-inverted version.
Thanks,
Bobossa
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.