http://www.flickr.com/photos/33622597@N05/3230215048/
At least the inductors are all perpendicular to each other. Is there anything to correct?
At least the inductors are all perpendicular to each other. Is there anything to correct?
Your layout is good. The short distance between the steel core and the air core in the middle is perfectly fine since they are orthogonal. I measured a case where two of them are nearly touching each other. It was still okay.
I would move the top one to the right side of the middle one.
-jAy
I would move the top one to the right side of the middle one.
-jAy
Saturnus said:
it's actually better to have it spread out all over the backpanel.
Right
Or you could say its ok to have some distance between woofer section and tweeter section
Saturnus may think of when people cramp it all together tightly to make all components reach each other to avoid additional wire...something one should not do
Theres no harm done in using a bit of solid core wire
I believe I can hear that it sounds better when each section have each their own dedicated ground wire from speaker terminals
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.