For sale is a plate amplifier I built using hypex parts and an eliot sound 17hz 36db/oct. subsonic fitler for use with peerless XXLS drivers or similar setups with either ported or passive design. It consists of the following:
1 UcD 400 AD module
1 ST power supply
1 AVEL 500VA Transfomer
1 Soft Start module
1 Tamper resistant aluminum momentary button
Single ended and Balanced connections
1 12" X 12" aluminum pannel
Fuse holder
IEC power connec tor
custom heat sink
optional but not installed:
eliot sound subsonic filter with wima caps and TI op amps
15V power supply - would need to be monted and wired to the pannel.
This all cost me about $500.00+
I'm asking $350.00 Firm
The pannel hasn't even been drilled yet to install in a speaker. I have decided to go with a much bigger sub then I had planned, and will be using a 4 Kw watt pro amp instead with my deqx for filtering.
Please ask for photos since it was too big to atatch. Thanks
1 UcD 400 AD module
1 ST power supply
1 AVEL 500VA Transfomer
1 Soft Start module
1 Tamper resistant aluminum momentary button
Single ended and Balanced connections
1 12" X 12" aluminum pannel
Fuse holder
IEC power connec tor
custom heat sink
optional but not installed:
eliot sound subsonic filter with wima caps and TI op amps
15V power supply - would need to be monted and wired to the pannel.
This all cost me about $500.00+
I'm asking $350.00 Firm
The pannel hasn't even been drilled yet to install in a speaker. I have decided to go with a much bigger sub then I had planned, and will be using a 4 Kw watt pro amp instead with my deqx for filtering.
Please ask for photos since it was too big to atatch. Thanks
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.