I REPLACED THE OUTPUTS IN THIS AMP ALONG WITH THE DRIVER IC'S AND A 330 OHM RESISTOR ON THE DRIVERBOARD.
WHEN TRYING TO POWER THE AMP UP THE RELAYS CLICK ON FOR A SEC THEN CLICK OFF AND AMP GOES INTO PROTETION.
IF I REMOVE THE OUTPUT DRIVERBOARD AMP POWERS UP BUT THE GREEN LED DOESNT LIGHT WITH OR WITHOUT THE DRIVERBOARD.
ANY IDEAS ON WHERE TO CHECK?
WHEN TRYING TO POWER THE AMP UP THE RELAYS CLICK ON FOR A SEC THEN CLICK OFF AND AMP GOES INTO PROTETION.
IF I REMOVE THE OUTPUT DRIVERBOARD AMP POWERS UP BUT THE GREEN LED DOESNT LIGHT WITH OR WITHOUT THE DRIVERBOARD.
ANY IDEAS ON WHERE TO CHECK?
Back to this amp again.
I replaced all outputs and let the amp sit for awhile now when i try power it up it draws excessive current.
If i disable the output section amp powers up fine and idles around 5 amps.
I checked all outputs in the amp they all tested fine I also have the output driverboard removed.
Any thoughts on where to check or do i need to take all outputs back out of the amp and check for leakage?
I replaced all outputs and let the amp sit for awhile now when i try power it up it draws excessive current.
If i disable the output section amp powers up fine and idles around 5 amps.
I checked all outputs in the amp they all tested fine I also have the output driverboard removed.
Any thoughts on where to check or do i need to take all outputs back out of the amp and check for leakage?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Hifonics Sampson