Leave the 2-3 bridges.
Solder the 10k resistor to the points indicated by the arrows below. One end to any green. The other end to any yellow.
Driving a signal into the amp, do you see the same drive frequency square wave at pin 1 of the two 21844s?
Solder the 10k resistor to the points indicated by the arrows below. One end to any green. The other end to any yellow.
Driving a signal into the amp, do you see the same drive frequency square wave at pin 1 of the two 21844s?
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Hifonics BXI-6000D