I am changing the opamps to getter ones...
I'm sure it's not plate through and I have lifted all 8 legs.
The body is glued to the board and I can't seem to get anything under it to pry it up.
Is there a special tool to lift the opamps?
When i removed the other opamps on the same board I found signal traces under the body and I'm afraid ir I pry to hard I may pull the traces off the board!!!
I'm sure it's not plate through and I have lifted all 8 legs.
The body is glued to the board and I can't seem to get anything under it to pry it up.
Is there a special tool to lift the opamps?
When i removed the other opamps on the same board I found signal traces under the body and I'm afraid ir I pry to hard I may pull the traces off the board!!!
Just swapped some smd opamps from my dvd player:
Bend a small L shaped hook on a needle (soft burned in a flame) Heat each pin of oa and lift pin up with the custom hook. When you lifted the 4 pins on 1 side lift whole opamp. Bend opamp few times and so break off the other 4 pins. Remove excess solder/pin remains with wick.
Bend a small L shaped hook on a needle (soft burned in a flame) Heat each pin of oa and lift pin up with the custom hook. When you lifted the 4 pins on 1 side lift whole opamp. Bend opamp few times and so break off the other 4 pins. Remove excess solder/pin remains with wick.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Digital Line Level
- Help removing opamps!!