My OEM radio has the 92 - 99 amplified system harness. Thinking i was doing all right, i bought a 6 disc changer, but payed no attention to the pin out of it. This new readio has the 2000 - up harness. See pics below.
I can make the conections with the following kits of Metra:
which look like this:
My current one
The new one
However i still have questions>>>>>
If you see the picture of the new deck:
what is a shield ground. I need to connect this without problems.... Also my old deck has 1 power antenna, the new one has 3 power antennas, what do i do with the rest.
The rest i can pretty go by colors..... Thanks in advance...
An externally hosted image should be here but it was not working when we last tested it.
I can make the conections with the following kits of Metra:
An externally hosted image should be here but it was not working when we last tested it.
which look like this:
My current one
An externally hosted image should be here but it was not working when we last tested it.
The new one
An externally hosted image should be here but it was not working when we last tested it.
However i still have questions>>>>>
If you see the picture of the new deck:
what is a shield ground. I need to connect this without problems.... Also my old deck has 1 power antenna, the new one has 3 power antennas, what do i do with the rest.
The rest i can pretty go by colors..... Thanks in advance...
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.