Grrr..I have been trying to construct little cap/reg Assemblies using
reg113s the size of grains of rice .
At first I thought, yeah this will be fine..just bend the legs a little and presto! ....but oooh no..Snap! one gone.
Try again ...Snap another gone... .
OK I am sure I can fit these without bending .
Success!!
Made 4 .
Fifth one measures well under voltage.
I am now worried all the devices have had their performance
degraded in sneaky unseen ways .
Sot Package not used in intended way = .
Feeling gloomy now..all the fun of diy sucked out.... want to throw
all the components away and take up something nice .
I think it is time for
Setmenu
Hi 5th element
I hope your sanity was not tested tooo far .
What is a PCM2902?..not to expensive I hope
I have managed to cobble together enough reg units for my needs, but being so small and sensitive to heat ,i am now paranoid about them.[dunno whether to use them now]
I have been looking at some bigger alternative ldo regs in the form of LT1963s , seem nice and BIG..
Of course in the good ol UK finding them [in less than 5000 quantities] should be fun
OH why OH why, does nobody stock the bits.......
Still I have had me and feel a bit better now .
Have a good weekend.
Setmenu
I hope your sanity was not tested tooo far .
What is a PCM2902?..not to expensive I hope
I have managed to cobble together enough reg units for my needs, but being so small and sensitive to heat ,i am now paranoid about them.[dunno whether to use them now]
I have been looking at some bigger alternative ldo regs in the form of LT1963s , seem nice and BIG..
Of course in the good ol UK finding them [in less than 5000 quantities] should be fun
OH why OH why, does nobody stock the bits.......
Still I have had me and feel a bit better now .
Have a good weekend.
Setmenu
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.