Well I have fixed these before, but this is a new problem. This particular amp had the caps on the input board actually rotted off. I did the usual U.S. cleaning with 10-1 simple green. Replaced all the input board caps, and the OpAmp. I am getting very low DC offset in the ,10mv range, but the sound is very distorted, and is only pushing, and not pulling Any ideas? Both rails are 85 vdc, and the fuses are good.
Thanks
Ben
Thanks
Ben
Did the second one. Job went good. One crappy resistor was on the board. Looked like a Rat Shack 1/2 watt in place of a 1/4 watt metal film. Well that is changed, and the DC offset is <4mv on this one. All new caps, and an OpAmp.
Ben
Thanks Chris. I could have never done this without your help. Hope things are well.
Ben
Ben
Thanks Chris. I could have never done this without your help. Hope things are well.
Ben
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.