I'm selling one pair of lightly used Accuton C173-6-096E 6.5" Ceramic Dome Bass/Midrange drivers. I've never owned a better driver.
They sell for $909USD/each at Madisound:
https://www.madisoundspeakerstore.c...amic-cone-woofer/midrange-neodymium/?mobile=0
I'm asking $SOLD$ for the pair.
/////////////
The C173-6-096E is a 6.5 inch bass-midrange driver with ultra hard ceramic dome. Anti-resonant cutout fills in the ceramic dome provide for damping of the 6 kHz dome resonance. A FEA optimized underhung motor design with 55 mm titanium voice coil former guarantees very low energy storage and good heat transfer. Its high force factor leads to outstanding transient response for more realistic reproduction. The low loss rubber surround and a thin fabric spider center the moving parts with high linearity.
For this amazing bass-midrange driver, we recommend an application from 40 Hz - 3000 Hz.
Special Dome Cutouts
Underhung Motor Design
Neodymium Magnet
55mm Titanium VC Former
Soft Rubber Surround
Vented VC, Pole Piece & Spider
They sell for $909USD/each at Madisound:
https://www.madisoundspeakerstore.c...amic-cone-woofer/midrange-neodymium/?mobile=0
I'm asking $SOLD$ for the pair.
/////////////
The C173-6-096E is a 6.5 inch bass-midrange driver with ultra hard ceramic dome. Anti-resonant cutout fills in the ceramic dome provide for damping of the 6 kHz dome resonance. A FEA optimized underhung motor design with 55 mm titanium voice coil former guarantees very low energy storage and good heat transfer. Its high force factor leads to outstanding transient response for more realistic reproduction. The low loss rubber surround and a thin fabric spider center the moving parts with high linearity.
For this amazing bass-midrange driver, we recommend an application from 40 Hz - 3000 Hz.
Special Dome Cutouts
Underhung Motor Design
Neodymium Magnet
55mm Titanium VC Former
Soft Rubber Surround
Vented VC, Pole Piece & Spider
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.