I can definitely not use MiniDSP for low section of DTQWTII. Eminence speakers will strike the end of the coil against the pole piece. Little Xmax. I have done tests and gradually increasing the level is reached to perceive a small patter. Imminent danger of destruction of the speakers.
So I am again evaluating.
I was offered PolkAudio DSW660 at a good price, but they tell me it's not so good for music.
I also offer Klipsch, but here I do not have a high level connection and as I recommend bespav, I could do the following voltage divider ..... but I'm not sure if it applies for a valvular amplifier output. (Will not I damage the output transformers?)
Sorry OT
Speaker signal to line level
So I am again evaluating.
I was offered PolkAudio DSW660 at a good price, but they tell me it's not so good for music.
I also offer Klipsch, but here I do not have a high level connection and as I recommend bespav, I could do the following voltage divider ..... but I'm not sure if it applies for a valvular amplifier output. (Will not I damage the output transformers?)
Sorry OT
Speaker signal to line level
Maybe you have some answers in this thread ....
Subwoofer circuit: Going from speaker level to line level
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.