Wow, looks like a lot of effort was put in the build!
What is that finish ?
it's lacquered mdf
bye,
Chris
Very lovely! You do fine work, Christian.
What is that foil-covered material labelled "StP?"
"STP SILVER is a self-adhesive, flexible and elastic, 2mm-thick sound insulating material. This sound deadening sheet is a multilayer combination of an aluminum foil and a polymeric layer on butyl rubber base (alu-butyl)."
It's tipically used in car audio and it's very stable during the years.
How do they sound? Sonic strengths and weaknesses?
I like them so much, very neutral, great mid-high and very deep basses.
I'm using these speakers with hypex ncore 400 and I think they are extremely sincere and doesn't colour anything.
I'm finishing my Nelson Pass Aleph p1.7 ...I'll post some additional photos when it's ready.
The setup I've in mind is based on two ekta grande speakers + 1 ekta-like central channel and two surround speakers.
I've already designed from the ground a multi-channel aleph p1.7 and it will be paired with some hypex modules.
When the pre is ready I will start to create the ekta-like central channel.
Bye,
Chris
Astounding Christian!
He-he, I'm just wondering why the tweeters aren't on top?!
I've followed the project of Troels Gravesen and as I can see they are in the right place
Yeah,I've followed the project of Troels Gravesen and as I can see they are in the right place
Troels is so boring that he never leaves a space for improvement...
He's great.
Yeah,
Troels is so boring that he never leaves a space for improvement...
He's great.
lol ...you are right
I'll experiment a bit more when I'll start to build a central channel based on ekta grande
Crossover question
Wow, lovely job! I am also contemplating building a version of the Ekta Grande and would be grateful if you could answer a question for me.
I notice that you kept the bi-wire binding posts but bridged them. Did you have to make any change to the cross over design on Troel's site to allow bridging. I just want to have one set of binding posts on mine.
Wow, lovely job! I am also contemplating building a version of the Ekta Grande and would be grateful if you could answer a question for me.
I notice that you kept the bi-wire binding posts but bridged them. Did you have to make any change to the cross over design on Troel's site to allow bridging. I just want to have one set of binding posts on mine.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Loudspeakers
- Multi-Way
- ekta grande