Hi.. I like how your front and rear panel looks.. is that a custom one off?
-joe
Thanks! I did them...I did make a batch of front panels. Rear panels are stock but I did laser engraving on them.
An externally hosted image should be here but it was not working when we last tested it.
vs.
---
the input and output jacks are not the same.. and the power plug is switched.. I would like it closer to jtwrace layout for the rear.. makes more sense
-joe
Yes I would order 2 of these chassis too, if the rear panel is like the 2nd picture.
A power switch is a good idea, and a rear switched IEC connector works well.
A small power switch on the bottom panel, near the front also works well. That way it is out of sight, but easily reached.
I find the front logo slighty large. Can you make the logo 50% of that original size?
A power switch is a good idea, and a rear switched IEC connector works well.
A small power switch on the bottom panel, near the front also works well. That way it is out of sight, but easily reached.
I find the front logo slighty large. Can you make the logo 50% of that original size?
Of course it's possible. we do custom order start from only 10pcs.
I will take 10 pcs if you make that panel
-joe
Hi Joe, no problem for that. Please send the cad file to sales@siliconray.com.
Has that other panel ever been made?
Regards
Sven
PS: And why is it mandatory in your store to add Shipping and handling for each (!) of the cases and then another time during checkout? 3 times shipping and handling seems to be plenty?
Sorry about the confusion. This setting is due to the system limitation. The back end has a fixed $10 shipping cost for each order. So we have to divide the cost into 2 part. for example if the shipping is $40, we'll charge $30 when ordering and $10 when checkout. But, whatever the order quantity is, the $10 shipping & handling fee will only be charged once. That means the more you order the lower the average shipping cost. That is exactly the way how the shipper charge us.
Very nice faceplate.
Not much of a design the backplate(especially the center holes)
An AC inlet with button would be very useful .
I would love a box 7' X 10' (D x W) same height.This way you can put Ncore &SMPS side by side keeping the the mantatory distances and shortest cabling.
Not much of a design the backplate(especially the center holes)
An AC inlet with button would be very useful .
I would love a box 7' X 10' (D x W) same height.This way you can put Ncore &SMPS side by side keeping the the mantatory distances and shortest cabling.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- More Vendors...
- Siliconray Online Electronics Store
- Custom nCore mono chassis