Hello!
My actual board layout was a rough pencil
sketch laid out by a blown up Xerox copy
of a 0.1" board hole pattern. If you think
of the layout in terms of using the upper
and lower surfaces of the board, you will
discover that there are ways to deal with
the power rails and signal lines without
their crossing each other. The use of the
board hole layout sketching can be very
useful in solving this problem.
Fastcat
My actual board layout was a rough pencil
sketch laid out by a blown up Xerox copy
of a 0.1" board hole pattern. If you think
of the layout in terms of using the upper
and lower surfaces of the board, you will
discover that there are ways to deal with
the power rails and signal lines without
their crossing each other. The use of the
board hole layout sketching can be very
useful in solving this problem.
Fastcat
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.