Hello,
I want to connect Philips SAA7210 to Analog Device AD1852 Evaluation Board. The idea is to transfer non over sampling data thru I2S interface.
I am little confused about different codes used from Philips and Analog Device. Philips codes are:
DAAB – SD Data Output
CLAB - SCL Clock
WSAB – Word Select
Analog Device codes are:
L/RCLK - Left/Right clock input for input data. Must run continuously.
BCLK - Bit clock input for input data
SDATA - Serial input, MSB first, containing two channels of 16/18/20/24 bit twos-complement data
I am going to connect in that way:
DAAB – SDATA
CLAB - BCLK
WSAB – L/RCLK
Do you think this is the right way?
Best regards,
Angel
I want to connect Philips SAA7210 to Analog Device AD1852 Evaluation Board. The idea is to transfer non over sampling data thru I2S interface.
I am little confused about different codes used from Philips and Analog Device. Philips codes are:
DAAB – SD Data Output
CLAB - SCL Clock
WSAB – Word Select
Analog Device codes are:
L/RCLK - Left/Right clock input for input data. Must run continuously.
BCLK - Bit clock input for input data
SDATA - Serial input, MSB first, containing two channels of 16/18/20/24 bit twos-complement data
I am going to connect in that way:
DAAB – SDATA
CLAB - BCLK
WSAB – L/RCLK
Do you think this is the right way?
Best regards,
Angel
Hello,
I want to connect Philips SAA7210 to Analog Device AD1852 Evaluation Board. The idea is to transfer non over sampling data thru I2S interface.
I am little confused about different codes used from Philips and Analog Device. Philips codes are:
DAAB – SD Data Output
CLAB - SCL Clock
WSAB – Word Select
Analog Device codes are:
L/RCLK - Left/Right clock input for input data. Must run continuously.
BCLK - Bit clock input for input data
SDATA - Serial input, MSB first, containing two channels of 16/18/20/24 bit twos-complement data
I am going to connect in that way:
DAAB – SDATA
CLAB - BCLK
WSAB – L/RCLK
Do you think this is the right way?
Best regards,
Angel
I am facing the same problem with different use of the same codes. Did you ever sort this?
It is specific to the 7210/7220/1541 setup.
DAAB - Data. A-chip to B-chip. DABD -Data. B-chip to DAC.
Thanks. If I do an NOS mod, can I remove the B chip and send the signal directly from the A chip to the DAC. And, can I also send that signal to the the S/PDIF?
I remember an article in the Audio Amateur magazine from the 90s, that had exactly this topic.
Ask there for the appropriate issue:
About Us | audioXpress
Ask there for the appropriate issue:
About Us | audioXpress
I remember an article in the Audio Amateur magazine from the 90s, that had exactly this topic.
Ask there for the appropriate issue:
About Us | audioXpress
Thanks but no matter what search terms I use I cannot find back articles of that magazine which went out of existence when the publisher retired.
I remember an article in the Audio Amateur magazine from the 90s, that had exactly this topic.
Connect the SAA7210 to the AD1862 ? I very much doubt that.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Digital Source
- CD Philis/SAA7210 to AD1852 trou I2S ?