i am new one from chinese .
my english is not well , sorry .
my cambridge a3i had little hiss in left channel , need x-pro help .
Q7 ¡¢Q107¡¢Q101, Q102 is all good , what can i do ?
need Cambridge A3i schematics ,
my email address : leon428@sohu.com
x-pro £¬please email me £¬ i cant know your email. thanks very much.
my english is not well , sorry .
my cambridge a3i had little hiss in left channel , need x-pro help .
Q7 ¡¢Q107¡¢Q101, Q102 is all good , what can i do ?
need Cambridge A3i schematics ,
my email address : leon428@sohu.com
x-pro £¬please email me £¬ i cant know your email. thanks very much.
Cambrigde A3i, no sound and output transistors get very hot
Hello, I see what there is no posts since 2007. I hope the cause that the amp Cambrigde A3i run fault free. I’m in order to improve my sonic environment and my choice has felt on Cambrigde A3i, because the comments in forums were full of joy about it sound. Unfortunately, my decision to buy it second hand, this time, was wrong. The amplifier has the similar problem as it was described in the post from h4x0r_n1 from 14 april 2007. After 4-6 minutes relay clicks, there is no sound and the output transistors get very hot. I did not notice if one LED went out or not. But I want hear how it sounds!
If somebody could help me: with advice or schematics, I would very appreciate it!
Hello, I see what there is no posts since 2007. I hope the cause that the amp Cambrigde A3i run fault free. I’m in order to improve my sonic environment and my choice has felt on Cambrigde A3i, because the comments in forums were full of joy about it sound. Unfortunately, my decision to buy it second hand, this time, was wrong. The amplifier has the similar problem as it was described in the post from h4x0r_n1 from 14 april 2007. After 4-6 minutes relay clicks, there is no sound and the output transistors get very hot. I did not notice if one LED went out or not. But I want hear how it sounds!
If somebody could help me: with advice or schematics, I would very appreciate it!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.