Building Bela's aka euro21 801A preamp https://www.diyaudio.com/community/threads/801a-tube-preamp.395883/
I will use Ale's Moglia aka Bartola Hybrid mu-follower as anode load.
I will need to mod the Vout LT PSU for filaments, I have a couple of Lundahls Filament Current Choke LL1694 that can be configured as serial or parallel also common mode choke and choke input. Could be configured as choke input CMC?
More questions will follow.
TIA
I will use Ale's Moglia aka Bartola Hybrid mu-follower as anode load.
I will need to mod the Vout LT PSU for filaments, I have a couple of Lundahls Filament Current Choke LL1694 that can be configured as serial or parallel also common mode choke and choke input. Could be configured as choke input CMC?
More questions will follow.
TIA
Not cheap https://es.rs-online.com/web/p/transformadores-de-montaje-en-pared/0504101
Better paralleled LL1594 coil as input choke than CMC Bela?
Better paralleled LL1594 coil as input choke than CMC Bela?
"Not cheap https://es.rs-online.com/web/p/transformadores-de-montaje-en-pared/0504101"
It's 2x 30V/50VA, so even enough for both channel.
CMC is good for common mode disturbation (generates rectifiers both on ground and B+).
Input choke generates less stress on secondary, less stress on first capacitor, so it's another animal.
It's 2x 30V/50VA, so even enough for both channel.
CMC is good for common mode disturbation (generates rectifiers both on ground and B+).
Input choke generates less stress on secondary, less stress on first capacitor, so it's another animal.
More important is that primary and secondary isolation be realized.
See this Indel transformer:
https://www.tme.eu/es/details/ts40_041/transformadores-con-sujecion/indel/ts-40-041/
I usually use this type transformers with separated bobbin parts.
See this Indel transformer:
https://www.tme.eu/es/details/ts40_041/transformadores-con-sujecion/indel/ts-40-041/
I usually use this type transformers with separated bobbin parts.
RS only have datasheet that I attach but I didn't see the info https://docs.rs-online.com/5556/A700000008747406.pdf
Attachments
The one on the right would be good (24-0-24 with two diode) ... but 24VAC not enough for this choke input, 22V DC output raw supply.
If you use this PT as there (C-r-CMC-C) will be OK.
p.s.
If you use 24VCT with very low (for example 0.1R) DCR input choke (and R.C. V9), the raw supply output voltage criterium accessible.
If you use this PT as there (C-r-CMC-C) will be OK.
p.s.
If you use 24VCT with very low (for example 0.1R) DCR input choke (and R.C. V9), the raw supply output voltage criterium accessible.
Last edited:
- Home
- Amplifiers
- Tubes / Valves
- Building Euro21 801A tube preamp