Hello ! I just want to say that my noise problem with my bride of zen is now gone. Today, I receive the new Plitron transformer and they put a magnetic shield around the transfo. Now, I have no noise at all even at very high level !!!
My Zen V4 was off during more that 2 mounth.
Thank you to everybody who helped me.
My Zen V4 was off during more that 2 mounth.
Thank you to everybody who helped me.
Bride Of Zen Problem
Can anyone tell me what is the physical size of the Bride of Zen Preamp PCB downloaded from the Pass site??.When I print it out it looks small for the components to be fitted..Please can someone give me the size..Please if you can email it to me .. jackyjack21@yahoo.com
Thanks..
Can anyone tell me what is the physical size of the Bride of Zen Preamp PCB downloaded from the Pass site??.When I print it out it looks small for the components to be fitted..Please can someone give me the size..Please if you can email it to me .. jackyjack21@yahoo.com
Thanks..
drain res = 1k (R104)
pot = 5k (linear)
if the pot is fully turned up: 1k parallel 5k = 830 ohm;
if the (linear) pot is half turned up: you get 1k + 2,5k = 3,5k in the signal path
and 2,5k parallel to the path.........this gives you in parallel near by 1,5k....
and that is the maximum output impedance.
pot = 5k (linear)
if the pot is fully turned up: 1k parallel 5k = 830 ohm;
if the (linear) pot is half turned up: you get 1k + 2,5k = 3,5k in the signal path
and 2,5k parallel to the path.........this gives you in parallel near by 1,5k....
and that is the maximum output impedance.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- Bride of Zen problem