audiopipe1800d protect problems

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
You need 10 of the IRF640N FETs but you need 10 with a matching date code (or you need the ones on each side to have matching date codes). If you order by phone, you may be able to request matching date codes. I don't know if that's possible if you order online. The part at digi-key is:
IRF640NPBF-ND

You'll also need to remove the old heatsink compound and replace it. You can get a small tube of it at Radio Shack.

What are the numbers on the gate resistors?

What does your meter read when you touch the probes together (set to ohms)?

Before you attempt any repair, you need to measure the DC voltage between the center and outer legs of the rectifiers (fully encapsulated on the heatsink). If it's not near 0v, you need to discharge the rail caps. If you don't apply power to the amp until the transistors arrive, they should discharge on their own.
 
DO NOT !!! order them off ebay .. Some of the parts on ebay are counterfit parts and you may get all shorts of problems with the amp after replacing the outputs..


So in other words you may run into a problem with the parts off ebay and then try to track down a problem that dosent exsist..


Many people on here will agree never to order them off ebay ..

Hope this helps.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.