This little driver really has caught my attention. I have searched and found only limited mention of this driver both on diyaudio and the web in general... though Zaph has measured it and seemed fond of it.
Bear in mind two things, I have never designed a loudspeaker, but also it interests me to use this driver nearly full range.
- Would a simple notch filter be suitable for taming the top end of this driver's response?
- Is 150Hz-20kHz a reasonable bandwidth to run this driver?
- For the above bandwidth, I should use a sealed enclosure, correct?
I'll leave my questions at that for now - hopefully they are not too idiotic! Hope to see some responses.
Bear in mind two things, I have never designed a loudspeaker, but also it interests me to use this driver nearly full range.
- Would a simple notch filter be suitable for taming the top end of this driver's response?
- Is 150Hz-20kHz a reasonable bandwidth to run this driver?
- For the above bandwidth, I should use a sealed enclosure, correct?
I'll leave my questions at that for now - hopefully they are not too idiotic! Hope to see some responses.
Attachments
Several DIY designs for this driver have recently been done. Here area couple: http://htguide.com/forum/showthread.php4?t=25932
http://htguide.com/forum/showthread.php4?t=27222
http://htguide.com/forum/showthread.php4?t=26939
http://htguide.com/forum/showthread.php4?t=27222
http://htguide.com/forum/showthread.php4?t=26939
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.