Hello!
I want to make a pair of aleph 3 monoblocs and all I ve found for the power supplies are 220 va toroids with 2X21 v or 2X15v outputs
the real thing will do with 2X18v ( I guess)
so I must take a compromise; higer voltage with low amperage or the opposite.
any advice will be greatly apreciated!
and merry christmas to all.....
I want to make a pair of aleph 3 monoblocs and all I ve found for the power supplies are 220 va toroids with 2X21 v or 2X15v outputs
the real thing will do with 2X18v ( I guess)
so I must take a compromise; higer voltage with low amperage or the opposite.
any advice will be greatly apreciated!
and merry christmas to all.....
I vote for the 21V, which will give you roughly 28V rails. Then use a CRC(RCRC...) filter on the power supply to drop the voltage along with the ripple. The Aleph circuits aren't overly sensitive about rail voltage, so if you end up with 24 or 27V rails it'll work just fine.
Grey
Grey
From Spain
Karrellen, my english level is very bad.
I make de Aleph 3 or 30, can you write me a email please?
Thanks.
isabido@ibersilva.es
Karrellen, my english level is very bad.
I make de Aleph 3 or 30, can you write me a email please?
Thanks.
isabido@ibersilva.es
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- Aleph 3 transformer question