Hi Guys
I am working on a GFA545 that has a bit of DC offset at the output, and I see a couple of slightly bulging elec.caps. Amp works fine otherwise. Would be most excellelant to have a Sckematic to see what is going on there. Any chance you might be so kind as to send a PDF my way? Would be very grateful.
Thanks a Bunch!
artmielke@yahoo.com
I am working on a GFA545 that has a bit of DC offset at the output, and I see a couple of slightly bulging elec.caps. Amp works fine otherwise. Would be most excellelant to have a Sckematic to see what is going on there. Any chance you might be so kind as to send a PDF my way? Would be very grateful.
Thanks a Bunch!
artmielke@yahoo.com
I would greatly appreciate a copy as well! speakerman@rocketmail.com
thank you!!
thank you!!
Thanks Craig. I need one too. Got one channel down. Please send to:
michaelchua@ampslab.com
michaelchua@ampslab.com
I would greatly appreciate a copy too, please email to kc8pnn@sbcglobal.net Thanks
popular post
Craig
I just picked one of these up. I could use a copy as well.
thanks
-John
jallen@oz.net
Craig
I just picked one of these up. I could use a copy as well.
thanks
-John
jallen@oz.net
Hi Craig ,
Could I get the ADCOM GFA-545II service manual . Please send me one . My amplifier burned both R619 & R620 and 4 fuses 4A . My email address is haitran47@ymail.com . Thank you very much .
Could I get the ADCOM GFA-545II service manual . Please send me one . My amplifier burned both R619 & R620 and 4 fuses 4A . My email address is haitran47@ymail.com . Thank you very much .
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Solid State
- Adcom 545 Schematics needed