Hi,
There are some SMD caps already on the PCB. You could either tap the signal off these or take it off the input end and use better caps to carry the ac signal to the Aikido input.
If you have a diagram of the board then it's pretty straightforward to figure out.
Ciao,
but think you would need a series cap to get the DC out
There are some SMD caps already on the PCB. You could either tap the signal off these or take it off the input end and use better caps to carry the ac signal to the Aikido input.
If you have a diagram of the board then it's pretty straightforward to figure out.
Ciao,
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.