http://www.classdaudio.co.cc/doc/ClassD/Fredos/ClassD.pdf
As for PCB, I don't, no I DO NOT recomend you use my, also its better for you in the end if you make your own, really just take time
As for PCB, I don't, no I DO NOT recomend you use my, also its better for you in the end if you make your own, really just take time
http://www.classdaudio.co.cc/doc/ClassD/Fredos/ClassD.pdf
As for PCB, I don't, no I DO NOT recomend you use my, also its better for you in the end if you make your own, really just take time
OK I read you had problems with you pcb. WHY? The traces ware too long?
This is maybe noob question but I'll ask it. This is only the driving circuit right? Now I need separate PCB with powerful output transistors right?
Last edited:
well there are some smart thing one should do when switching high currents and two of them are short high current paths, and 2nd is ground plane, which I didn't then think about
I think you didn't see my edited post so I'll ask this noob question again.
Is this only the driver? Do I need to connect power transistors at the output of this PWM?
Ca you show me how you do that? Thanks.
I think you didn't see my edited post so I'll ask this noob question again.
Is this only the driver? Do I need to connect power transistors at the output of this PWM?
Ca you show me how you do that? Thanks.
It is a complete amp, including power output mosfets, mounted underneath of PCB (TO-247 package)...
It is a complete amp, including power output mosfets, mounted underneath of PCB (TO-247 package)...
OK Thank you. I'll see the schematic again and I'll try to make PCB.
I'll post it here.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Class D
- 200-300 W class D amplifier? schematic? project?