Creek OBH-21SE doesn't power up after I've connected the DAC output during music playing to the headphone amp's output (RCAs). What did I do?! Could you help me please?
photo of the circuit board below
P.S: Creek's engraved msg on the back of the amp: "No user serviceable parts inside" is very discouraging.
photo of the circuit board below
P.S: Creek's engraved msg on the back of the amp: "No user serviceable parts inside" is very discouraging.
Attachments
I've been trying to troubleshoot the 14-pin TL074CN.
Please let me know if I'm doing it correctly. Thank you
- With the headamp's DC power OFF
- Multimeter in diode mode
- I've measured each pin to ground:
1(1OUT): 0.74V
2(1IN-): .0L
3(1IN+): 0.0V
4(VCC+): 0.95V
5(2IN+): 0.0V
6(2IN-): .0L
7(2OUT): 0.74V
8(3OUT): 0.74V
9(3IN-): .0L
10(3IN+): 0.0V
11(VCC-): 0.54V
12(4IN+): 0.0V
13(4IN-): 0L
14(4OUT) 0.74V
===
With the amp's DC power ON
Multimeter in V mode,
I've measure the VCC+/- to ground:
VCC+: 0.54V
VCC-: 0.0V
Please let me know if I'm doing it correctly. Thank you
- With the headamp's DC power OFF
- Multimeter in diode mode
- I've measured each pin to ground:
1(1OUT): 0.74V
2(1IN-): .0L
3(1IN+): 0.0V
4(VCC+): 0.95V
5(2IN+): 0.0V
6(2IN-): .0L
7(2OUT): 0.74V
8(3OUT): 0.74V
9(3IN-): .0L
10(3IN+): 0.0V
11(VCC-): 0.54V
12(4IN+): 0.0V
13(4IN-): 0L
14(4OUT) 0.74V
===
With the amp's DC power ON
Multimeter in V mode,
I've measure the VCC+/- to ground:
VCC+: 0.54V
VCC-: 0.0V
Last edited:
Yes, The DC source puts out 24V. I’ve measured it with a meter.
What value should it be, at Vin to ground is 0.48V?
.... need to be checked....
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Headphone Systems
- Creek OBH-21SE doesn't power up