1000W Simple PA Amplifier

[tinitus]

more toys for the happy hobbyist

 

[apexaudio]

then it's probably much cheaper to buy plug and play stuff

personally I only think of this as a hobby, and mostly about having fun
saving money here will not be easy
but andrelebon is clever and skilled
he might save a penny or two

You can save money if you use some old amp and repare it with new pcbs.

 

[dovizci]

with +-60v supply after a while 2sa1837 and the transistor at cross side warming up . what must I do?

 

[apexaudio]

with +-60v supply after a while 2sa1837 and the transistor at cross side warming up . what must I do?

VAS work in class A and transistors must be on main heatsink with outputs.

 

[wiljj78]

Willy can you resize BA1200 pcb for 3U heatsink as option?

for 3U heatsink, pcb size is 260 X 115mm.

Regards,

 

[apexaudio]

for 3U heatsink, pcb size is 260 X 115mm.

Regards,

Nice work, amp pcb with protect add.
Regards

 

[apexaudio]

I suggest signal, clip, protect leds and fan control instead auto range vu...

 

[wiljj78]

I suggest signal, clip, protect leds and fan control instead auto range vu...

Copy that...

 

[khalsa]

very nice design sir wiljj78

 

[khalsa]

please share in sprint layout . khalsaaudiocenter@yahoo.com

 

[wiljj78]

very nice design sir wiljj78

Thanks...

 

[suryadi5417]

I hope you don't mind to share in pdf sir,
Regads

 

[Boedy]

for 3U heatsink, pcb size is 260 X 115mm.

Regards,

good design sir willy...
Waiting for completed new design,,,,

regard

 

[John Cory]

Been Looking for designs like these for a long time.
I've got some old mosfet amps to rebuild so this is going to come in very handy.
Thanks,
John thesoundman

 

[SYAHRUL]

You can use this simple DC protection with 40A relay (12V for car)

hi apex..
i'm a simulation dc protect and delay,but relay non aktif.
R470k replece 300k relay on.

 

[AndrewT]

Q1 needs to pass the relay coil current when turned on.
When turned on Q1 must have low Vce to prevent it blowing up.

You achieve this by running Q1 saturated, i.e. very high base current. Aim for Ic/Ib ~ 10

R4 (10k) is starving Q1.

 

[SYAHRUL]

Q1 needs to pass the relay coil current when turned on.
When turned on Q1 must have low Vce to prevent it blowing up.

You achieve this by running Q1 saturated, i.e. very high base current. Aim for Ic/Ib ~ 10

R4 (10k) is starving Q1.

Much obliged.
I will make from this scheme.

 

[vedmitraa]

Is there some d.c.protection and soft start with 24 volt relay?

 

[SYAHRUL]

Is there some d.c.protection and soft start with 24 volt relay?

I WANT TO START THIS PROJECT FOR TRIAL

 

[mihailo]

24V D.C. protection.