Will,Hi Alan,
Same RG project, same request for 4 pcbs, please.
Thanks,
Will
Four boards put aside for you.
Down to 15.
Alan
They must have walked all the way to Italy!!Hi Alan, got the pcbs yesterday
They must have walked all the way to Italy!!
This it typical across Xmas holidays., plus extra delay due to some closed airport for snow.
Thanks Alan!!
Last 15 - Come on, folks!! This is the last chance you will have for these manufactured boards. It'll be "etch you own" time after this!!!
Jon,
There are a few people who have shown interest but not yet confirmed.
So probably even less left.
Alan
Bob,Hi
I have just caught up with this thread and I would like to order two boards if there are any left.
Thanks
Bob
Two boards set aside - I will reply to your pm.
Alan
This is the end....
Jon,
I like the idea - could even pass it onto the NEXT GB!
SO CONSIDER THAT THE END OF THE GB - MANY THANKS TO EVERYONE WHO CONTRIBUTED TO THE CHARITY.
Regards
Alan
I think you should keep it as an official record / design reference of the run, Alan.
I have one such board here from the first run for posterity...
Well done for completing Part 2!! A great job done and more ££ to a good cause! Thanks for taking it on!
Jon,
I like the idea - could even pass it onto the NEXT GB!
SO CONSIDER THAT THE END OF THE GB - MANY THANKS TO EVERYONE WHO CONTRIBUTED TO THE CHARITY.
Regards
Alan
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Group Buys
- John Linsley Hood Ripple Eater - Part 2